Written price before work
Agreed before any repair work begins.
Shower and tub services in Conyers cover the parts of a bathroom that fail behind walls and under tubs: a valve that will not hold temperature, a cartridge worn by mineral content, a drain that slows, an overflow that leaks, or a fixture ready for replacement. SoCo Plumbers diagnoses the valve, drain and supply during business hours, Monday to Friday, 9 AM to 5 PM, and agrees a written price before any wall is opened.
Every shower and tub services visit follows the same core scope: diagnose first, agree the price and scope in writing, do the work, and test before leaving.


For Conyers homes: shower valves that will not hold temperature, tub drains that slow, leaking overflows and new shower or tub installs, handled during business hours.
Offices, restaurants, shops and multi-family buildings with shower or tub faults get the same valve-first approach during business hours, with repeat faults across units noted for the property record.
A shower or tub fault is usually a valve, a cartridge or a drain — but which one matters, because the repair route differs completely. A valve that will not hold temperature points to a cartridge or a pressure-balance fault; a drip from the showerhead with the valve closed points to a seat or cartridge; a slow tub drain points to the drain line or the overflow assembly; water appearing below a tub points to the drain, the overflow or the valve connections behind the wall. Our faucet installation and repair work covers the same valve logic at sinks, and our drain cleaning work covers the drain end; shower and tub work joins the two behind the bathroom wall.
Conyers conditions shape the faults. Mineral content leaves scale on showerheads, cartridges and valve seats, causing drips and reduced flow, and older homes carry corroded brass fittings and worn valve seats while newer builds carry plastic valve bodies that can crack. Drain connections and backflow provisions follow Rockdale County code requirements, and work is built to the 2024 International Plumbing Code with Georgia Amendments, effective 1 January 2026. A valve repaired onto a failing supply line is a job half done, so supply lines and shut-offs are checked on every visit.
Find whether it is valve, cartridge or drain, then repair that part.
From the first call to the final test, here is the sequence for a shower and tub services visit in Conyers, booked during business hours.

Used to loosen old valve nuts and cut copper or PEX supply lines cleanly so we can replace cartridges and fittings without damaging the surrounding pipe.

A drain snake clears hair and soap scum from tub drains. When the clog is heavier, a hydro jetter blasts away grease and scale with high-pressure water.

We run a sewer camera through the tub drain to see what's causing a backup. It finds root intrusion, broken pipes, and heavy buildup without tearing out the floor.

Used to find hidden leaks behind shower walls and under tubs. It helps us locate the source without opening more of the wall than necessary.

A press tool crimps standard parts and copper fittings without soldering. A torch kit is used when we need to solder copper pipe for a permanent repair.

Every shower and tub repair follows the UPC and Georgia amendments. We use the correct pipe materials, secure every joint, and test under full pressure so the work passes inspection.

After any repair, we run the shower for at least 10 minutes and check every joint with a dry rag. We also fill the tub to the overflow and let it drain to confirm the waste line is sealed.

We match new parts to your existing plumbing. If your home has copper pipe, we use copper or standard parts fittings. If it has PEX tubing, we use PEX and brass fittings to avoid corrosion.
Temperature swings or scalding when another fixture runs point to a cartridge or pressure-balance fault. The valve is tested and the failed part replaced.
A drip with the valve closed means a seat or cartridge fault, not a showerhead fault. The valve is assessed and repaired where the body is sound.
A slow tub drain can be a local blockage, a venting fault or a drain-line problem. Each is checked in order before any clearing is recommended.
Water below a tub points to the drain, the overflow or the valve connections. The source is located before any wall or floor is opened.
Shower and tub work in Conyers follows fixture era and water chemistry. Older homes carry original copper supply lines, corroded brass fittings and worn valve seats, while newer builds carry PEX tubing and valve bodies that fail differently. Mineral content scales showerheads, cartridges and valve seats, causing drips and reduced flow across both eras. Drain connections and backflow provisions follow code requirements, and supply lines are checked on every visit, since a valve fault and a supply fault often present identically at the showerhead.
A shower ran hot whenever another fixture in the house was used, making it unsafe for children.
Testing found a failed pressure-balance cartridge. Replacing it restored stable temperature, tested with other fixtures running.
Temperature swings when another tap opens point to the valve cartridge. Note which fixtures trigger the swing before the visit.
A tub drained more slowly over weeks, with no single blockage event to explain it.
The drain and overflow assembly were checked, a build-up in the drain line was cleared, and flow was tested at full volume.
A drain that slows gradually is a build-up or venting fault, not a single blockage. Note the timescale.
Water stained the ceiling below a tub, with no leak visible in the bathroom itself.
The drain and overflow were tested before any opening, locating a failed overflow seal. Repairing it stopped the leak without opening the wall beyond the located joint.
Water below a tub is a drain-or-overflow clue first. Testing locates it before any wall is opened.
Most shower and tub calls fall into a handful of categories. Here are the ones we see most often in Conyers and how each is handled.

Cartridge and pressure-balance function are tested. The failed part is replaced where the valve body is sound.

Seat and cartridge are assessed. A showerhead drip is usually a valve fault, not a showerhead fault.

Drain, overflow and venting are checked in order, so a blockage is not treated as a venting fault or vice versa.

Overflow seals and drain connections are tested before any opening, so the repair follows the located source.
You agree the price and the scope before work starts. Oct-2026 Atlanta market data on this page is background only, never a quote for your job — call for a written price before work.
Shower and tub work is built to the 2024 International Plumbing Code with Georgia Amendments, effective 1 January 2026. Permits are checked with the City of Conyers or Rockdale County as applicable, where a replacement changes valves or drainage.
A shower fault is not guessed at. Valve, cartridge, drain and overflow are tested in order, so the repair matches the part that actually failed.
Repaired and replaced valves and drains are run and checked for leaks before we pack up, and old parts are shown to you so you can see what was replaced.
Clear records you can keep and share.
Agreed before any repair work begins.
Every fitting and fixture noted on the invoice.
Line tested and confirmed before we leave.
Three observations make a shower or tub visit faster. Here is what to note before calling.
Note which other fixtures trigger a swing. That pattern points directly to the valve cartridge.
A drip with the valve closed and low flow while running are different faults. Note which you have.
Water at the showerhead, at the tub rim, or below the tub each point to a different part. Note the location.

Call to confirm coverage in your part of Conyers and Rockdale County. +17708971640
4.7 stars from 7 Google reviews · Read reviews on Google
Monday to Friday, 9 AM to 5 PM; Saturday and Sunday closed. If a burst pipe or sewer backup happens outside those hours, shut off the water, stop running water, and call +17708971640 at 9 AM. If you smell gas, leave the building first and call 911 or your gas utility — do not wait for a plumber.
No firm price is possible before the valve type and fault are known. As background only, Oct-2026 Atlanta market data, not SoCo Plumbers' prices — call for a written price before work.: Angi's Atlanta average for a plumber visit was $316 (range $174–$460) in July 2026. A written price is agreed after diagnosis.
That points to a pressure-balance or cartridge fault in the shower valve: when another fixture draws cold water, the valve fails to compensate. The cartridge is tested and replaced where the valve body is sound.
Usually the valve. A showerhead drip with the valve closed means the valve is not shutting off, and replacing the head alone will not stop it. The valve is assessed first.
A shower that will not hold temperature, a tub that drains slowly, or a leak below a tub — call SoCo Plumbers at +17708971640 during business hours. Valve, cartridge or drain, identified first.
Call SoCo Plumbers Monday to Friday, 9 AM to 5 PM for shower and tub service. Tell us whether it is temperature, drip, drainage or a leak below, and what triggers it.